Perbandingan Elemen Struktur Yang Dicetak Dengan Bekisting Alumunium Dan Konvensional Dengan Metode Six Sigma
DOI:
https://doi.org/10.56911/jik.v3i2.126Kata Kunci:
Alumunium, Bekisting, Konvensional, Mutu, Six SigmaAbstrak
Bekisting konvensional untuk saat ini masih menjadi pilihan terbanyak bagi pelaksana industri konstruksi di Indonesia. Namun dengan perkembangan metode konstruksi, metode bekisting konvensional mulai digantikan dengan metode bekisting lainnya, penggunaan bekisting konvensional mulai digantikan dengan metode bekisting lain, seperti bekisting alumunium. Secara umum penelitian ini bertujuan untuk mengetahui perbandingan antara bekisting alumunium dan bekisting konvensional dari segi mutu beton yang dihasilkan. Objek pada pada penelitian ini adalah pekerjaan pemasangan bekisting lantai 10 sampai 12 pada Tower 2 dan Tower 3 di Proyek Pembangunan Rumah Susun proyek X. Hasil dari analisis terhadap mutu yang dihasilkan dari bekisting alumunium didapatkan nilai 4,6 sigma sehingga telah mencapai standarisasi kualitas industri USA, dan untuk analisis terhadap mutu yang dihasilkan dari bekisting konvesional didapatkan nilai 3,49 sigma sehingga telah mencapai standarisasi kualitas industri Indonesia tingkat atas. Dari penelitian tersebut dapat disimpulkan bahwa bekisting alumunium lebih unggul daripada bekisting konvesional dalam menghasikan kualitas beton yang lebih kompetitif.
Conventional formwork is currently still the most popular choice for construction industry implementers in Indonesia. However, with the development of construction methods, conventional formwork methods began to be replaced by other formwork methods, such as aluminum formwork. In general, this study aims to find out the comparison between aluminum formwork and conventional formwork in terms of the quality of the concrete produced. The object of this study is the installation of formwork on the 10th to 12th floors in Tower 2 and Tower 3 in the Flats Construction Project of Project X. The results of the analysis of the quality produced from aluminum formwork obtained a value of 4.6 sigma so it has reached the standardization of the quality of the USA industry. For the analysis of the quality produced from conventional formwork, a value of 3.49 sigma was obtained so that it has reached the top level of Indonesia's industrial quality standardization. From the study, it can be concluded that aluminum formwork is superior to conventional formwork in producing more competitive concrete quality.
Unduhan
Diterbitkan
Terbitan
Bagian
Lisensi
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Copyright Notice
An author who publishes in the Jurnal Inovasi Konstruksi agrees to the following terms:
- Author retains the copyright and grants the journal the right of first publication of the work simultaneously licensed under the Creative Commons Attribution-ShareAlike 4.0 License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal
- Author is able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book) with the acknowledgement of its initial publication in this journal.
- Author is permitted and encouraged to post his/her work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of the published work (See The Effect of Open Access).
Read more about the Creative Commons Attribution-ShareAlike 4.0 Licence here: https://creativecommons.org/licenses/by-sa/4.0/.
